Visual Inspection Method

Complete the following steps in order to perform the visual inspection method:

1. Bring the vehicle to normal operating temperature.
2. Park the vehicle over a large sheet of paper, or other clean surface.
3. Wait several minutes, then inspect for dripping fluids.
4. Identify the type of fluid, and the approximate location of the leak.
5. Visually inspect the suspected area. Use a small mirror if necessary.
6. Inspect for leaks at sealing surfaces, fittings, or from cracked or damaged components.
7. If you cannot locate the leak, perform the following steps:
   1. Completely clean the entire engine and surrounding components.
   2. Operate the vehicle for several miles at normal operation temperature and at varying speeds.
   3. Park the vehicle over a large sheet of paper, or other clean surface.
   4. Wait several minutes, then inspect for dripping fluids.
   5. Identify the type of fluid, and the approximate location of the leak.
   6. Visually inspect the suspected area. Use a small mirror if necessary.
8. If you still cannot locate the leak, use the powder method or the black light and dye method.