Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
You must perform Circuit/System Verification before proceeding with Circuit/System Testing.
- Ignition OFF, disconnect the C1 harness connector at the transmission control module (TCM).
- Test for less than 1.0 ohm between ground circuit terminal 9 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, replace the TCM.
- If all circuits test normal, replace the TCM.