LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 3.4L - DTC P0401 To DTC P2544) >> DTC P1682 >> Circuit/System Testing >> Testing the EC Ignition Relay Feedback Circuit

Testing the EC Ignition Relay Feedback Circuit

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: A resistance of 5 ohms or greater in the circuit will cause the DTC to set.
  1. Ignition OFF, remove the powertrain relay from the underhood fuse block.
  2. Ignition ON, connect a 3A fused jumper wire from B+ to the powertrain ignition 1 voltage circuit terminal. Verify that the EC Ignition Relay Feedback parameter displays B+ on the scan tool.
    • If the scan tool parameter is less than the specified value, test the ignition 1 voltage circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the ECM.
scientia non olet · About LEMON Manuals