Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0122, P0123, P0128, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0443, P0502-if applicable, P0503-if applicable, P1174, P1175, or P2135, is not set.
The engine has been running for greater than 60 seconds.
The engine is idling for more than 10 seconds.
The AC mode state has not changed.
The power steering load state has not changed.
The transmission gear selector state has not changed.
The engine coolant temperature (ECT) is more than -40°C (-40°F).
The intake air temperature (IAT) is more than -40°C (-40°F).
The barometric pressure (BARO) is more than 72 kPa.
The system voltage is between 9-18 volts.
The vehicle speed is less than 4.8 km/h (3 mph).
The DTCs run continuously when the above conditions are met.