P0452 and P0453
WARNING: This page is about a different variant/trim than selected.
- If DTC P0641 is set, repair that DTC first.
- With the ignition OFF, disconnect the harness connector at the FTP sensor.
- With the ignition ON, the scan tool FTP sensor parameter should indicate 0 volts.
- If the parameter is more than 0 volts, test for unexpected voltage at the signal circuit. If the circuit tests normal, replace the ECM.
- With the ignition ON, measure for 4.8-5.2 volts between the 5-volt reference circuit of the FTP sensor and ground.
- If over 5.2 volts, test for unexpected voltage at the 5-volt reference circuit. If the circuit tests normal, replace the ECM.
- If under 4.8 volts, test for a short to ground, or open/high resistance at the 5-volt reference circuit. If the circuit tests normal, replace the ECM.
- With the ignition ON, the scan tool FTP sensor parameter should indicate 4.8-5.2 volts with a 3A fused jumper wire connecting the FTP signal circuit to the 5-volt reference circuit.
- If under 4.8 volts, test for a short to ground or an open at the signal circuit. If the circuit tests normal, replace the ECM.
- If the circuits and ECM test OK, replace the FTP sensor.
- With the ignition OFF and the ECM powered down, measure for less than 5 ohms between the low reference circuit of the FTP sensor and a good ground.
- If greater than 5 ohms, test for an open/high resistance in the circuit. If the circuit tests normal, replace the ECM.