Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON and fuel cap removed, verify the FTP sensor parameter is between 1.3-1.7 volts.
- If greater than the specified range, refer to the FTP sensor section in Circuit/System Testing .
- Install the fuel cap.
- With the engine running, the EVAP canister vent solenoid valve open, and the EVAP canister purge solenoid valve commanded to 100 percent, the fuel tank vacuum should not increase to more than 8 inches H2O.
- If greater than the specified range, refer to the restriction section in Circuit/System Testing .