P2A01 - Intrusive Test

WARNING: This page is about a different variant/trim than selected.

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1133, P1516, P2101, P2119, P2135, P2176, P2A00 are not set.
The Engine Run Time parameter is more than 5 minutes.
The ignition voltage is between 10-18 volts.
The Engine Speed parameter is between 625-1,650 RPM.
The MAF Sensor parameter is between 4-15 g/s.
The Vehicle Speed parameter is between 40-132 km/h (25-82 mph).
When all of the above conditions have been met for at least 2 seconds, the following conditions must also be met:
- The evaporative emission (EVAP) purge diagnostic is not active.
- The Short Term FT parameter is between +5 and -5 percent.
- The Loop Status parameter is closed.
- The EVAP purge solenoid is greater than 0 percent.