Conditions for Running the DTC: P2A00
WARNING: This page is about a different variant/trim than selected.
- DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1133, P1516, P2101, P2119, P2120, P2122, P2123, P2135, P2176 are not set.
- The Engine Run Time parameter is more than 100 seconds.
- The MAF Sensor parameter is between 5-37 g/s.
- The Engine Speed parameter is between 500-3,000 RPM.
- The ECT Sensor parameter is more than 75°C (167°F).
- The ignition 1 signal parameter is between 10-18 volts.
- DTC P2A00 runs continuously when the above conditions are met for 5 seconds.