Conditions for Running the DTC: P1133

WARNING: This page is about a different variant/trim than selected.

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2119, P2135,, P2176, P2A00 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The HO2S Sensor 1 Heater command parameter is ON.
The ECT Sensor parameter is more than 65°C (149°F).
The Engine Run Time parameter is at least 60 seconds.
The EVAP purge solenoid is commanded ON.
The MAF sensor parameter is between 15-40 g/s.
The Engine Speed parameter is between 1,200-3,000 RPM.
The TP Indicated Angle parameter is greater than 2.5 percent.
The Loop Status parameter is closed.
The BARO parameter is at least 69.8 kPa.
The vehicle is not in Park, Reverse, or Neutral.
The above conditions have been met for 3 seconds.