Conditions for Running the DTC: P0141

WARNING: This page is about a different variant/trim than selected.

DTCs P0036, P0054, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The Engine Run Time parameter is at least 180 seconds.
The ECT parameter is at least 65°C (149°F).
The MAF Sensor parameter is between 5-30 g/s.
The Engine Speed parameter is between 500-3,000 RPM.
The above conditions have been met for more than 6 seconds.