Fuel Injector Balance Test-Fuel Pressure Test
WARNING: This page is about a different variant/trim than selected.
- Install a fuel pressure gage. Refer to Fuel Pressure Gage Installation and Removal .
- Turn ON the ignition, with the engine OFF.
- The fuel pump relay may need to be commanded ON a few times in order to obtain the highest possible fuel pressure.
- DO NOT start the engine.
- Command the fuel pump relay ON with a scan tool.
- Observe the fuel pressure gage with the fuel pump commanded ON. The fuel pressure should be 384-425 kPa (56-62 psi).
- If the fuel pressure is not 384-425 kPa (56-62 psi), refer to Fuel System Diagnosis .
- Monitor the fuel pressure gage for one minute. The fuel pressure should not decrease more than 34 kPa (5 psi).
- If the fuel pressure decreases more than 34 kPa (5 psi), refer to Fuel System Diagnosis .
- Perform Fuel Injector Balance Test with Special Tool or Fuel Injector Balance Test with Tech 2 .
IMPORTANT: