Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the X2 harness connector at the clutch control module.
- Ignition ON, verify a test lamp does not illuminate between the following circuits and ground:
- low reference terminal 2
- signal terminal 4
- If the test lamp illuminates, test the appropriate circuit for a short to voltage.
- Ignition OFF, test for infinite resistance between the following circuit terminals and ground:
- low reference terminal 2
- signal terminal 4
- If less than the specified value, test the appropriate circuit for a short to ground.
- Test for 310-113 K ohms between the low reference circuit terminal 2 and the signal circuit terminal 4.
- If greater than the specified range, test the appropriate circuit for an open/high resistance. If the circuits test normal, replace the rear wheel drive module clutch housing.
- If all circuits test normal, replace the CCM.