Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the X2 harness connector at the clutch control module.
- Ignition ON, verify a test lamp does not illuminate between the following circuits and ground:
- Low Reference terminal 3
- Voltage terminal 5
- If the test lamp illuminates, test the appropriate circuit for a short to voltage.
- Ignition OFF, test for infinite resistance between the following circuit terminals and ground:
- Low Reference terminal 3
- Voltage terminal 5
- If less than the specified value, test the appropriate circuit for a short to ground.
- Test for less than 5.0 ohms between the low reference circuit terminal 3 and the voltage supply terminal 5.
- If greater than the specified range, test the appropriate circuit for an open/high resistance. If the circuits test normal, replace the rear wheel driver module clutch housing.
- If all circuits test normal, replace the CCM.