LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of HO2S 2 & Harness Connector
    GM1370518Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the HO2S 2 harness connector (3).
    3. IMPORTANT: Silicone based products will contaminate the HO2S. DO NOT use products containing silicone on or near the HO2S.
  3. Use a liquid penetrate before removing the sensor.
  4. Remove the HO2S 2 (2) from the exhaust pipe.
scientia non olet · About LEMON Manuals