LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor 1 Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of HO2S 1
    GM1087793Courtesy of GENERAL MOTORS CORP.
    NOTE: Silicone based products will contaminate the HO2S. Use only a nickel based anti-seize compound that does not contain silicone.
  1. Apply a small amount of anti-seize compound to the threads of the HO2S.
    2. NOTE: Refer to Component Fastener Tightening Notice .
  2. Install the HO2S to the exhaust manifold.

    Tighten:  Tighten the HO2S to 42 N.m (31 lb ft).

  3. Connect the engine wiring harness electrical connector to the HO2S. Push in the connector until a click is heard and pull back to confirm a positive engagement.
scientia non olet · About LEMON Manuals