LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Purge Hose/Pipe
    GM1371130Courtesy of GENERAL MOTORS CORP.
  1. Remove the nuts (1) securing the evaporative emission (EVAP) hose/pipe (2) to the strut tower.
  2. Disconnect the EVAP purge hose/pipe (2) from the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: View Of EVAP Purge Pipe
    GM879155Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the engine EVAP purge hose/pipe from the chassis EVAP purge hose/pipe. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Cap or plug both the engine and chassis EVAP purge hose/pipes to prevent contamination.
    5. Fig 3: View Of EVAP Purge Hose/Pipe
    GM1371130Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP hose/pipe (2) from the retainer (3).
  6. Remove the EVAP hose/pipe (2) from the vehicle.
scientia non olet · About LEMON Manuals