LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  1. Position the purge pipe to the vehicle.
  2. Install the purge pipe to the pipe retainers.
  3. Secure the pipe retainers (1) to the vehicle underbody.
    4. Fig 2: View Of Evaporative Emission Canister
    GM1226407Courtesy of GENERAL MOTORS CORP.
  4. Remove the caps or plugs from both the EVAP purge hose/pipe and canister.
  5. Connect the EVAP purge hose/pipe to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Lower the vehicle.
    7. Fig 3: View Of EVAP Purge Pipe
    GM879155Courtesy of GENERAL MOTORS CORP.
  7. Remove the caps or plugs from both the engine and chassis EVAP purge hose/pipes.
  8. Connect the engine EVAP purge hose/pipe to the chassis EVAP purge hose/pipe. Refer to Plastic Collar Quick Connect Fitting Service .
scientia non olet · About LEMON Manuals