LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister, Hose/Pipes & EVAP Vent Solenoid Electrical Connector
    GM1371134Courtesy of GENERAL MOTORS CORP.
  1. Connect the EVAP vent solenoid electrical connector (1).
  2. Install the EVAP canister (4) to the underbody of the vehicle.
    3. Fig 2: View Of Chassis Fuel Supply Line, EVAP Canister Purge Hose/Pipe & EVAP Canister-To-Underbody Nuts
    GM1371133Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister-to-underbody nuts (3).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  4. Connect the chassis EVAP pipe (1) to the EVAP canister.
    5. Fig 3: View Of EVAP Canister, Hose/Pipes & EVAP Vent Solenoid Electrical Connector
    GM1371134Courtesy of GENERAL MOTORS CORP.
  5. Connect the fuel tank vent pipe (3) to the EVAP canister.
  6. Connect the EVAP canister fresh air hose/pipe to the fuel tank fresh air hose/pipe (2).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals