LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Purge Solenoid Valve & Retaining Bolt
    GM1087790Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP canister purge solenoid valve (1) on the intake manifold.
    2. NOTE: Refer to Fastener Notice .
  2. install the EVAP canister purge solenoid valve bolt (2).

    Tighten:  Tighten the EVAP canister purge valve retaining bolt to 10 N.m (89 lb in).

  3. Connect the EVAP canister purge solenoid valve hose/pipe.
  4. Connect the EVAP canister purge solenoid valve electrical connector.
scientia non olet · About LEMON Manuals