LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the CMP sensor O-rings with clean engine oil.
    2. Fig 1: View Of CMP Sensor
    GM1087797Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP sensor (1).
    3. NOTE: Refer to Fastener Notice .
  3. Install the CMP sensor bolt (2).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Connect the engine wiring harness electrical connector to the CMP sensor.
  5. Install the air cleaner inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
scientia non olet · About LEMON Manuals