LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Frame And Underbody) >> Repair Instructions >> Frame Replacement (LNJ) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower control arms. Refer to Lower Control Arm Replacement .
  2. Raise the frame to the body.
    3. Fig 1: View Of Frame
    GM1398170Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not tighten the fasteners at this time.
  3. Loosely install new frame-to-body bolts.
    4. Fig 2: View Of Ball Joint & Knuckle
    GM1826244Courtesy of GENERAL MOTORS CORP.
  4. Connect the ball joint stud to the steering knuckle.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the ball stud castle nut and tighten to 40 N.m (30 lb in).
    6. NOTE:
    • Do not loosen the castle nut in order to align the cotter pin slots.
    • Ensure the cutter pin ends do not contact the wheel speed sensor harness.
  6. Continue to tighten the castle nut to align the slots with the opening in the ball stud and install the ball stud cotter pin.
    7. Fig 3: View Of Steering Gear & Steering Gear-To-Frame Bolts
    GM927957Courtesy of GENERAL MOTORS CORP.
  7. Remove the mechanics wire and install the steering gear to the frame. Tighten the bolts to 110 N.m (81 lb ft).
    8. Fig 4: View Of Transmission Mount Bolt
    GM1398177Courtesy of GENERAL MOTORS CORP.
  8. Install the front transaxle mount through bolt and tighten to 110 N.m (81 lb ft).
    9. Fig 5: View Of Rear Transmission Mount & Bolts
    GM1398176Courtesy of GENERAL MOTORS CORP.
  9. Install the rear transaxle mount-to-frame bolts and tighten to 50 N.m (37 lb ft).
  10. Install the stabilizer shaft clamp and tighten the bolts to 50 N.m (37 lb ft).
  11. Tighten the frame-to-body bolts to 155 N.m (114 lb ft).
  12. Install the front air dam fasteners.
  13. Install the side splash shield-to-frame fasteners.
  14. Install the front wheels. Refer to Tire and Wheel Removal and Installation .
  15. Lower the vehicle.
  16. Release the radiator from the upper radiator support.
  17. Align the front suspension. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
scientia non olet · About LEMON Manuals