LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Accelerator Pedal Assembly
    GM925900Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal assembly to the brake pedal bracket. Refer to Accelerator Pedal Position Sensor Replacement .
    2. Fig 2: Removing/Installing Brake Pedal Assembly
    GM925895Courtesy of GENERAL MOTORS CORP.
  2. Install the brake pedal assembly into the vehicle, while guiding the brake pedal bracket pilot bushings into the foam insulator panel.
  3. Position the booster studs through dash panel.
    4. CAUTION: Refer to Fastener Caution .
    Fig 3: Removing/Installing Brake Pedal Bracket
    GM931272Courtesy of GENERAL MOTORS CORP.
  4. Install the brake pedal bracket-to-steering column bracket bolt and tighten to 25 N.m (18 lb ft).
  5. Loosely install the brake booster mounting nuts.
  6. Apply a thin coating of lithium grease to the pushrod pin on the brake pedal.
    7. Fig 4: Removing/Installing Washer & Retaining Clip To Brake Pedal
    GM926065Courtesy of GENERAL MOTORS CORP.
  7. Connect the brake booster pushrod to the brake pedal.
  8. Install the washer and retaining clip to the brake pedal.
    9. Fig 5: Removing/Installing Brake Pedal Assembly
    GM925895Courtesy of GENERAL MOTORS CORP.
  9. Tighten the vacuum brake booster mounting nuts to 25 N.m (18 lb ft).
    10. Fig 6: View Of Steering Column Bracket To Cowl Nut
    GM932996Courtesy of GENERAL MOTORS CORP.
  10. Install the steering column bracket to cowl nut and tighten to 25 N.m (18 lb ft).
  11. Connect the brake pedal position sensor electrical connector.
    12. Fig 7: View Of APP Sensor Harness Connector
    GM927716Courtesy of GENERAL MOTORS CORP.
  12. Connect the accelerator pedal assembly electrical connector.
  13. Install the communication interface module, if equipped. Refer to Communication Interface Module Replacement .
  14. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals