Installation Procedure
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Position the generator (2) to the engine.
- Loosely install the generator bolts (1).
- Install the idler pulley (3). Refer to Drive Belt Idler Pulley Replacement .
- Tighten the generator bolts to 50 N.m (37 lb ft).
- Install the generator wiring harness (2) terminal to the generator.
- Install the generator wiring harness nut (3) to the generator and tighten the nut to 20 N.m (15 lb ft).
- Position the generator wiring harness boot (1) at the generator terminal.
- Connect the engine wiring harness electrical connector (1) to the generator.
- Install the drive belt. Refer to Drive Belt Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution
.