Installation Procedure
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Lightly coat the new O-ring with mineral base 525 viscosity refrigerant oil.
- Install the new O-ring to the pressure relief valve. Refer to O-Ring Replacement .
- Install the pressure relief valve to the compressor and tighten the pressure relief valve to 8.8 N.m (78 lb in).
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
- Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
- Test the affected A/C joint for leaks using J 39400-A . See Special Tools .
NOTE:
Lubricate the new O-ring prior to installation on the compressor hose.
CAUTION:
Refer to Fastener Caution
.