Installation Procedure
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Add the proper amount of polyalkylene glycol (PAG) oil to the compressor (2). Refer to Refrigerant System Capacities .
- Install caps on compressor (2) to prevent spillage during installation.
- Install the compressor (2) to the vehicle.
- Install the spacer bracket (1) between the engine and the compressor (2).
- Install the compressor bolts to the compressor (2). Tighten the bolts in sequence.
- Tighten the bolt (5) to 50 N.m (37 lb ft).
- Tighten the bolt (3) to 50 N.m (37 lb ft).
- Tighten the bolt (4) to 50 N.m (37 lb ft).
- Remove the shipping cap from the compressor (2) and the compressor hose.
- Connect the electrical connector to the compressor (2).
- Install new seal washers to the compressor. Refer to Sealing Washer Replacement .
- Install compressor hose to the compressor.
- Position the compressor hose to the compressor and tighten the nut to 20 N.m (15 lb ft).
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
- Install the accessory drive belt to the compressor pulley. Refer to Drive Belt Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
- Test the affected A/C joints for leaks using J 39400-A . See Special Tools .
CAUTION:
Refer to Fastener Caution
.
CAUTION:
Refer to Compressor Hose Clearance to the Exhaust Gas Circulation Pipe Caution
.