LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Wiring Harness Removal

Wiring Harness Removal

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Solenoid Harness Connectors
    GM749337Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not damage the wiring harness connectors.
  1. Disconnect the wiring harness connectors 1-8.
    2. Fig 2: View Of Fluid Temperature Sensor
    GM749339Courtesy of GENERAL MOTORS CORP.
  2. Remove the fluid temperature sensor bolt (31).
  3. Remove the fluid temperature sensor clamp (49).
  4. Remove the fluid temperature sensor (36) and the O-ring (32) from the control valve body assembly.
    5. Fig 3: Locating A/T Control Wiring Harness Connector & Retainer
    GM1826678Courtesy of GENERAL MOTORS CORP.
  5. Remove the A/T control wiring harness connector retainer (69).
    6. Fig 4: View Of Transmission Wiring Harness Assembly
    GM1826683Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not break the wiring harness connectors or the fluid temperature sensor.
  6. Remove the transmission wiring harness assembly (33) from the transmission case assembly through the wiring harness bore.
  7. Remove the TCM seal (72) and the automatic transmission wiring connector seal (46) from the connector.
scientia non olet · About LEMON Manuals