LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Transmission Fluid Cooler Pipe Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert a new transaxle cooler line seal into the case bore.
    2. Fig 1: View Of Nub & J 41239-1
    GM992891Courtesy of GENERAL MOTORS CORP.
  2. Remove the nub from the J 41239-1A  . See Special Tools .
    3. Fig 2: View Of Nub Of J 41239-1 & Transaxle Cooler Line Seal
    GM948673Courtesy of GENERAL MOTORS CORP.
  3. Install the nub of the J 41239-1A  on the transaxle cooler line seal. See Special Tools .
  4. Tap the new transaxle cooler line seal into the case bore.
    5. Fig 3: View Of Transaxle Oil Cooler Line Assembly
    GM945444Courtesy of GENERAL MOTORS CORP.
  5. Install the transaxle oil cooler line assembly to the transaxle.
    6. CAUTION: Refer to Fastener Caution .
  6. Install the transaxle oil cooler line assembly nut and tighten to 9 N.m (80 lb in).
  7. Lower the vehicle.
    8. NOTE: DEXRON® VI automatic transmission fluid is not compatible with this transaxle. If DEXRON® VI ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid P/N 88900925.
  8. Add fluid to the transaxle. Refer to Transmission Fluid Check  procedure located in this service manual.
  9. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals