Transmission Fluid Cooler Pipe Fitting Seal Removal: Removal

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of J 45201

Courtesy of GENERAL MOTORS CORP.

Insert the collet (2) of the J 45201 completely into the fluid cooler pipe fitting seal (87).
Insert the forcing screw (1) of the J 45201 into the collet (2).
Tighten the forcing screw (1) until snug.

Fig 2: Identifying Collar & Collet

Courtesy of GENERAL MOTORS CORP.

Thread the collar (1) of the J 45201 onto the collet (3) until snug.

Fig 3: Removing Fluid Cooler Pipe Fitting Seal

Courtesy of GENERAL MOTORS CORP.

Using an adjustable wrench, turn the collar clockwise in order to remove the fluid cooler pipe fitting seal (87).
Discard the fluid cooler pipe fitting seal.
Clean the case bores for the fluid cooler pipe fitting seals as needed.