LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Output Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Output Shaft Speed Sensor With Bolt
    GM1827302Courtesy of GENERAL MOTORS CORP.
  1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new output speed sensor O-ring.
  2. Install the new output speed sensor O-ring onto the output speed sensor (2).
  3. Install the output speed sensor into the transmission case assembly.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the output speed sensor bolt and tighten to 5 N.m (44 lb in).
    5. Fig 2: Identifying Electrical Connector & Output Shaft Speed Sensor
    GM1827300Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2) to the output shaft speed sensor.
  6. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals