LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Oil Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transaxle Cooler Lines & Nut
    GM1285001Courtesy of GENERAL MOTORS CORP.
  1. Install the transaxle oil cooler lines into the vehicle.
  2. Install the transaxle oil cooler line assembly (1) to the transaxle.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the transaxle oil cooler line assembly nut (2) and tighten to 9 N.m (80 lb in).
  4. Connect the lower transaxle oil cooler line to the radiator.
    5. Fig 2: View Of Transaxle Oil Cooler Lines At Fan Shroud
    GM1655798Courtesy of GENERAL MOTORS CORP.
  5. Engage the transaxle oil cooler lines with the fan shroud by snapping in place.
  6. Lower the vehicle.
    7. Fig 3: View Of Transmission Cooler Lines At Radiator
    GM1655796Courtesy of GENERAL MOTORS CORP.
  7. Connect the upper transaxle oil cooler line to the radiator.
    8. NOTE: DEXRON® VI automatic transmission fluid is not compatible with this transaxle. If DEXRON® VI ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid P/N 88900925.
  8. Add fluid to the transaxle. Refer to the Transmission Fluid Check .
  9. Start the engine a check for leaks.
scientia non olet · About LEMON Manuals