Front Internal Gear and Low and Reverse Clutch Plate Assembly Removal: Removal

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Internal Gear Thrust Bearing

Courtesy of GENERAL MOTORS CORP.

Remove the front internal gear thrust bearing (529).

Fig 2: View Of Low & Reverse Clutch Plate Retaining Ring

Courtesy of GENERAL MOTORS CORP.

Remove the low and reverse clutch plate retaining ring (518) from the transmission case assembly with J 28585 .

Fig 3: Identifying Low And Reverse Clutch Assembly

Courtesy of GENERAL MOTORS CORP.

Remove the low and reverse clutch backing plate (520).
Remove the 5 low and reverse clutch fiber plate assemblies (516).
Remove the 4 low and reverse clutch steel plates (517).
Remove the low and reverse clutch apply plate (515).

Fig 4: View Of Front Internal Gear Thrust Bearing Assembly & Front Internal Gear

Courtesy of GENERAL MOTORS CORP.

Remove the front internal gear (526). The front internal gear thrust bearing assembly (519) and the thrust washer race (530) are on the back side of the front internal gear (526).