Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Case Fluid Passage Seals

Courtesy of GENERAL MOTORS CORP.

Install 2 new transaxle case fluid passage seals (86) into the transaxle case fluid ports.

Fig 2: View Of Valve Body Assembly

Courtesy of GENERAL MOTORS CORP.

While holding the control valve body assembly (39), connect the manual valve link (336) to the manual shift detent lever assembly (710).

Fig 3: View Of Valve Body Assembly-To-Transaxle Case Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 6 control valve body assembly to transaxle case bolts and hand tighten.

Fig 4: Identifying Control Valve Body Assembly-To-Transmission Case Bolts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Tighten the control valve body assembly-to-transaxle case bolts in sequence to 10 N.m (89 lb in).

Fig 5: View Of Control Valve Body Passage Cover Bolts, Cover & Gasket

Courtesy of GENERAL MOTORS CORP.

Install a new control valve body fluid passage cover gasket (38).
Install the control valve body fluid passage cover (37).
Install the 2 control valve body bolts (31) and tighten to 10 N.m (89 lb in).
Install the transmission wiring harness. Refer to Automatic Transmission Wiring Harness Replacement .
After the transmission is reassembled and filled with fluid perform the transmission adaptive learn procedure. Refer to Transmission Adaptive Learn and Transmission Neutral Learn .