LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Control Valve Body Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Control Valve Body Cover
    GM749819Courtesy of GENERAL MOTORS CORP.
  1. Clean any gasket material from the control valve body cover and inspect the gasket mounting surface.
  2. Install a 3 mm (0.125 in) bead of RTV sealer GM P/N 89020326 (Canadian P/N 89021188) onto the control valve body cover.
    3. Fig 2: View Of Control Valve Body Cover & Bolts
    GM1418667Courtesy of GENERAL MOTORS CORP.
  3. Install the control valve body cover (1) onto the transaxle case.
    4. NOTE: Use LOCTITE™ 242 thread sealer on ALL bolt threads.
  4. Install the control valve body cover bolts (2) hand tight.
    5. Fig 3: Identifying Control Valve Body Bolts/Screws Tightening Sequence
    GM749335Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Tighten the control valve body cover bolts in the sequence shown to 13 N.m (115 lb in).
  6. Install the transaxle oil cooler lines and seals to the transaxle. Refer to Transmission Fluid Cooler Pipe Seal Replacement .
  7. Install the front engine mount. Refer to Engine Front Mount Replacement .
  8. Install the left splash shield. Refer to Engine Splash Shield Replacement .
  9. Install the left front wheel and the tire assembly. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
  11. Check the transaxle fluid level. Refer to Transmission Fluid Check .
scientia non olet · About LEMON Manuals