LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> 2nd Coast Clutch Plate Assemble >> Assemble

2nd Coast Clutch Plate Assemble: Assemble

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Second Coast Clutch Piston & Seals
    GM1429629Courtesy of GENERAL MOTORS CORP.
  1. Apply automatic transmission fluid to the new second coast clutch piston seals.
  2. Install the new inner seal (221) and the outer seal (223) onto the second coast clutch piston (222).
  3. Apply automatic transmission fluid to the inner surfaces of the fluid pump stator shaft assembly.
  4. Press the second coast clutch piston (222) into the fluid pump stator shaft assembly.
    5. Fig 2: View Of Second Coast Clutch Spring Assembly
    GM1429630Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The transmission or the service parts may be either a 1st design or 2nd design second coast clutch spring (224). The 1st design (1) will have 15 springs and the 2nd design (2) will have 12 springs. The parts are completely interchangeable.
  5. Install the second coast clutch spring assembly (224) making sure to index the springs into the notches in the second coast clutch piston.
    6. Fig 3: View Of Second Coast Clutch Spring Retaining Ring
    GM1429627Courtesy of GENERAL MOTORS CORP.
  6. Place the J 21420-2 (1) and J 23327-2 (3), which are part of J 23327  , and J 41236  (2) on the second coast clutch spring (224), and compress the springs. See Special Tools .
  7. Using snap ring pliers, install the second coast clutch spring retaining ring (225) into the groove of the fluid pump stator shaft assembly.
    8. Fig 4: View Of Second Coast Plates
    GM1429626Courtesy of GENERAL MOTORS CORP.
  8. Install a steel plate (227) then a fiber plate (228). Repeat this sequence until all 6 plates have been installed.
  9. Install the second coast clutch backing plate (229).
    10. Fig 5: Removing/Installing Second Coast Clutch Backing Plate Retaining Ring
    GM749525Courtesy of GENERAL MOTORS CORP.
  10. Using J 45164  (2), J 21420-2 (4) and J 23327-2 (1), which are part of J 23327  , compress the second clutch spring. See Special Tools .
  11. Using J 28585  (3), install the second coast clutch backing plate retaining ring (230) into the groove of the fluid pump stator shaft assembly.
scientia non olet · About LEMON Manuals