LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> 2nd Clutch Disassemble >> Disassemble

2nd Clutch Disassemble: Disassemble

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Second Clutch Backing Plate Retaining Ring
    GM1429621Courtesy of GENERAL MOTORS CORP.
  1. Using J-28585:  remover remove the second clutch backing plate retaining ring (220) from the fluid pump assembly.
    2. Fig 2: View Of Second Clutch Assembly
    GM1826694Courtesy of GENERAL MOTORS CORP.
  2. Remove the second clutch backing plate (219).
  3. Remove the 4 fiber plates (217).
  4. Remove the 4 steel plates (218).
    5. Fig 3: View Of Second Clutch Spring Assembly
    GM1429624Courtesy of GENERAL MOTORS CORP.
  5. Remove the second clutch spring assembly (215).
    6. Fig 4: View Of Second Clutch Spring Assembly Retaining Ring
    GM749548Courtesy of GENERAL MOTORS CORP.
  6. Remove the second clutch spring assembly retaining ring (214).
    7. Fig 5: View Of Second Clutch Piston
    GM749550Courtesy of GENERAL MOTORS CORP.
    WARNING: Wear safety glasses when using compressed air in order to prevent eye injury.
  7. While pulling on the piston by hand, apply compressed air into the fluid passage and remove the second clutch piston (210) and the second clutch piston sleeve (212).
  8. Remove the second clutch piston outer seal (209) from the second clutch piston (210).
  9. Remove the second clutch piston sleeve seals (211, 213) from the second clutch piston sleeve (212).
scientia non olet · About LEMON Manuals