LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> 1-2-Reverse Clutch Plate Disassemble >> Disassemble

1-2-Reverse Clutch Plate Disassemble: Disassemble

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of 1-2 Reverse Clutch Plates
    GM749598Courtesy of GENERAL MOTORS CORP.
  1. Remove the 1-2 reverse clutch backing plate retaining ring (622) using J-28585:  remover.
  2. Remove the following components:
    • The 1-2 reverse clutch backing plate (621)
    • The 6 1-2 reverse clutch fiber plates (620)
    • The 6 1-2 reverse clutch steel plates (619)
    • The 1-2 reverse clutch apply plate (618)
    3. Fig 2: View Of 1-2 Reverse Clutch Piston Return Spring Retaining Ring
    GM749620Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not bend the 1-2 reverse clutch piston return spring assembly (601).
  3. Place J-45184:  installer (1) on the center of J-23456:  compressor (2).
  4. Place the transmission case cover (19) with the 1-2 reverse clutch piston assembly onto J-45184:  installer (1).
  5. Using J 23327-1 (3), which is the bridge part of J-23327:  compressor, compress the 1-2 reverse clutch piston return spring assembly (601).
  6. Remove the 1-2 reverse clutch piston return spring retaining ring (600) using snap ring pliers.
  7. Remove the pressure from J-23456:  compressor (2), remove J 23327-1 (3) and the 1-2 reverse clutch piston return spring assembly (601).
  8. Remove all tools.
    9. Fig 3: Identifying 1-2 Reverse Clutch Piston
    GM749628Courtesy of GENERAL MOTORS CORP.
    WARNING: Wear safety glasses when using compressed air in order to prevent eye injury.
  9. While pulling upward on the piston by hand, apply compressed air into the 1-2 reverse clutch fluid passage and remove the 1-2 reverse clutch piston (603).
  10. Remove the 1-2 reverse clutch piston inner seal (602).
  11. Remove the 1-2 reverse clutch piston outer seal (604).
scientia non olet · About LEMON Manuals