LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B3445 or B3884 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X3 harness connector at the I/P fuse block.
  2. Connect a test lamp between the control circuit terminal 5 and ground.
  3. Ignition ON, command the stop lamps ON and OFF by applying and releasing the brake pedal. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  4. Ignition OFF, connect the X3 harness connector at the I/P fuse block.
  5. Ignition OFF, disconnect the harness connector at the CHMSL.
  6. Ignition OFF, test for less than 5 ohms between the ground circuit terminal 2 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  7. Connect a test lamp between the control circuit terminal 1 and ground.
  8. Ignition ON, command the stop lamps ON and OFF by applying and releasing the brake pedal. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance.
  9. Ignition OFF, connect the harness connector at the CHMSL.
  10. Disconnect the X3 harness connector at the underhood fuse block.
  11. Ignition OFF, test for less than 5 ohms between the ground circuit terminal 2 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  12. Ignition OFF, connect the harness connector at the underhood fuse block.
  13. Disconnect the X2 harness connector at the underhood fuse block.
  14. Connect a test lamp between the control circuit terminal 15 and ground.
  15. Ignition ON, command the stop lamps ON and OFF by applying and releasing the brake pedal. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
    • If the test lamp is always OFF, test the control circuit X2 terminal 15 for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  16. If all circuits test normal, replace the underhood fuse block.
scientia non olet · About LEMON Manuals