LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Front Seat Replacement - Bucket >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Seat In Vehicle & Engaging The Front Adjuster Hooks
    GM987349Courtesy of GENERAL MOTORS CORP.
    NOTE: This step must be performed to assure proper timing of the adjusters.
  1. Adjust the seat adjuster tracks to the fully rearward position.
  2. Position the seat in the vehicle and engage the front adjuster hooks in the floor pan.
    3. Fig 2: Disconnecting/Connecting Heat Module Electrical Connector
    GM981887Courtesy of GENERAL MOTORS CORP.
  3. Connect the seat electrical connectors.
  4. Position the seat in the fully forward position to expose the rear bolt locations.
    5. Fig 3: Removing/Installing Front Seat Adjuster Bolts
    GM981927Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the seat adjuster bolts and tighten to 50 N.m (37 lb ft).
  6. Install the shoulder belt webbing in the quick disconnect anchor.
  7. Install the seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement (Non-Fold Flat)  or Front Seat Cushion Outer Trim Panel Replacement (Fold Flat) .
  8. Inspect the front seat belt for proper operation.
scientia non olet · About LEMON Manuals