Removal Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

When replacing an emblem/nameplate do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.
To remove an emblem/nameplate, heat the emblem/nameplate using a heat gun.
Apply the heat using a circular motion for about 30 seconds holding the heat gun approximately 152 mm (6 in) from the surface.

Fig 1: Identifying Adhesive Removal Tool

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Exterior Trim Emblem Removal Caution .

Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
When replacing, remove all adhesive as follows:
- For body panels use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
- For plastic panels use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to remove the adhesive.