LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Mechanical - 3.6L (4 Of 5)) >> Repair Instructions - Off Vehicle (2 Of 3) >> Camshaft Cover Cleaning and Inspection >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect each camshaft cover for the dents or damage to the exterior. A dented or damaged camshaft cover may:
    • Leak engine oil
    • Affect crankcase ventilation
    • Interfere with the camshafts
    • Interfere with the ignition coil sealing
    • Allow water or condensation to enter the engine
  2. Fig 1: Identifying Inspection Points of Left Camshaft Cover
    GM1864454Courtesy of GENERAL MOTORS CORP.
  3. Inspect the exterior of the left camshaft cover for the following conditions:
    • Damage to the camshaft cover bolt holes (1)
    • Damage to the oil fill hole (2)
    • Damage to the mounting holes (3) for the ignition coil assembly and fuel injector sight shield ballstud.
    • Damage to the positive crankcase ventilation (PCV) hose connector (4)-A damaged PCV hose connector is replaceable.
  4. Fig 2: View Of Interior Of Left Camshaft Cover Inspection Locations
    GM1864456Courtesy of GENERAL MOTORS CORP.
  5. Inspect the interior of the left camshaft cover for the following conditions:
    • Gouges or damage to the camshaft cover sealing groove (1)
    • Damaged, loose or missing baffle fasteners (2)
    • Damaged, loose or missing baffle (3)
    • Gouges or damage to the spark plug shield seal bore (4)
    • Restrictions to the ventilation system (5)
  6. Fig 3: View Of Right Camshaft Cover Inspection Locations
    GM1832353Courtesy of GENERAL MOTORS CORP.
  7. Inspect the exterior of the right camshaft cover for the following conditions:
    • Damage to the PCV orifice (1)-A damaged PCV orifice can be replaced. Refer to PCV Orifice Replacement .
    • Damage to the mounting holes (2) for the ignition coil assembly
    • Damage to the camshaft cover bolt holes (3)
  8. Fig 4: View Of Right Camshaft Cover Inspection Locations
    GM1832354Courtesy of GENERAL MOTORS CORP.
  9. Inspect the interior of the right camshaft cover for the following conditions:
    • Restrictions to the ventilation system (1)
    • Gouges or damage to the spark plug shield seal bore (2)
    • Gouges or damage to the camshaft cover sealing groove (3)
  10. Repair or replace the camshaft cover or covers as necessary.