Seat Vertical Motor
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate seat motor.
- Install a 30 A fused jumper wire between control terminal 2 or B and 12 V. Momentarily install a jumper wire between control terminal 1 or A and ground. The seat vertical motor should momentarily perform the UP function.
- If the function does not perform as specified, replace the seat vertical motor.
- Reverse the polarity of jumper wires; the a seat vertical motor should perform the DOWN function.
- If the function does not perform as specified, replace the seat vertical motor.
NOTE:
When performing the following tests, make sure that the seat is not all ready in the position the test is attempting to produce.