Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Push Rods

Courtesy of GENERAL MOTORS CORP.

Coat the ends of the push rods using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.

NOTE: The intake valve push rods measure 146.0 mm (5.75 in) in length. The exhaust valve push rods measure 152.5 mm (6.0 in) in length.

Install the push rods in their original location.

Fig 2: View Of Valve Rocker Arm

Courtesy of GENERAL MOTORS CORP.

Coat the rocker arm friction surfaces using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.

NOTE: Shims may be required under the valve rocker arm pedestals if reconditioning has been performed on the cylinder head or its components.

Install the valve rocker arms in their original positions.

CAUTION: Refer to Fastener Caution .

Install the valve rocker arm bolts and tighten to 32 N.m (24 lb ft).
Install the valve rocker arm cover(s). Refer to Valve Rocker Arm Cover Replacement - Left Side and/or Valve Rocker Arm Cover Replacement - Right Side .