LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Mechanical - 3.4L) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Installation - Right Side

Valve Rocker Arm Cover Installation - Right Side

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
    2. NOTE: All gasket-mating surfaces need to be free of oil and foreign material. Use P/N 12378392 or equivalent to clean surfaces.
    NOTE: Apply sealant GM P/N 12378521 (Canadian P/N 88901148), or equivalent, at the cylinder head to lower intake manifold joint.
  2. Install a new gasket to the valve rocker arm cover. Ensure that the gasket is properly seated in the groove of the valve rocker arm cover.
  3. Apply sealer GM P/N 12378521 (Canadian P/N 88901148), or equivalent to the joint surfaces (1) where the cylinder head and intake manifold meet.
    4. Fig 2: View Of Valve Rocker Arm Cover - Right
    GM60846Courtesy of GENERAL MOTORS CORP.
  4. Install the valve rocker arm cover.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the valve rocker arm cover bolts and tighten to 10 N.m (89 lb in).
    6. Fig 3: View Of Ignition Module & PCV Fresh Air Tube
    GM1369239Courtesy of GENERAL MOTORS CORP.
  6. Install the PCV fresh air tube (529).
  7. Install the ignition module studs (701). Tighten the ignition module studs to 25 N.m (18 lb ft).
  8. Install the ignition module with the ignition wires still attached (700).
  9. Install the ignition module nuts (702) and bolts (703). Tighten the ignition module nuts and bolts to 25 N.m (18 lb ft).
  10. Install the fresh air tube and wire harness retaining bolt (557). Tighten the fresh air tube and wire harness retaining bolt to 5 N.m (44 lb in).
    11. Fig 4: View Of MAP Sensor & Heater Outlet Pipe
    GM1369211Courtesy of GENERAL MOTORS CORP.
  11. Install the heater outlet pipe (309).
  12. Install the heater outlet pipe nuts and bolt (310, 311, 318) to the upper intake manifold.
    1. Tighten the heater outlet pipe nuts (310) and bolt (311) to 10 N.m (89 lb in) .
    2. Tighten the heater outlet pipe nut (318) to 25 N.m (18 lb ft) .
    3. Tighten the throttle body bolts (515) to 10 N.m (89 lb in) .
  13. Install the heater outlet pipe hose and hose clamp to the pipe.
  14. Install the manifold absolute pressure (MAP) sensor (506), clip (505), and bolt (504) to the intake. Tighten the MAP sensor bolt to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals