LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Mechanical - 3.4L) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Installation - Left Side

Valve Rocker Arm Cover Installation - Left Side

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
    2. NOTE: All gasket-mating surfaces need to be free of oil and foreign material. Use P/N 12378392 or equivalent to clean surfaces.
    NOTE: Apply sealant GM P/N 12378521 (Canadian P/N 88901148), or equivalent, at the cylinder head to lower intake manifold joint.
  2. Install a new gasket to the valve rocker arm cover. Ensure that the gasket is properly seated in the groove of the valve rocker arm cover.
  3. Apply sealer GM P/N 12378521 (Canadian P/N 88901148), or equivalent to the joint surfaces (1) where the cylinder head and intake manifold meet.
    4. Fig 2: View Of Valve Rocker Arm Cover - Left
    GM54369Courtesy of GENERAL MOTORS CORP.
  4. Install the valve rocker arm cover.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the valve rocker arm cover bolts and tighten to 10 N.m (89 lb in).
    6. Fig 3: View Of Foul Air Tube
    GM1369207Courtesy of GENERAL MOTORS CORP.
  6. Install the PCV fresh air tube (533).
  7. Install the PCV fresh air tube clip (534) and bolt (535). Tighten the PCV fresh air tube bolt to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals