LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Mechanical - 3.4L) >> Repair Instructions - Off Vehicle >> Oil Pump Assemble >> Assemble

Oil Pump Assemble: Assemble

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Drive Gear & Driven Gear
    GM5278Courtesy of GENERAL MOTORS CORP.
  1. Lubricate all the internal oil pump parts using engine oil during assembly.
  2. Install the oil pump gears.
    3. Fig 2: View Of Oil Pump Cover
    GM5277Courtesy of GENERAL MOTORS CORP.
  3. Install the oil pump cover.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the oil pump cover bolts and tighten to 10 N.m (89 lb in).
    5. Fig 3: View Of Pressure Regulator Valve & Spring
    GM5279Courtesy of GENERAL MOTORS CORP.
  5. Install the pressure regulator valve.
  6. Install the pressure regulator spring.
  7. Install the cotter pin.
    8. NOTE: Make sure the cotter pin is properly secured.
  8. Apply sealer GM P/N 12346004, (Canadian P/N 10953480) or the equivalent to the new suction pipe.
  9. Tap the new suction pipe into place using J 22144:  installer and a plastic hammer.
scientia non olet · About LEMON Manuals