LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Mechanical - 3.4L) >> Repair Instructions - Off Vehicle >> Engine Front Cover Installation

Engine Front Cover Installation

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Applying Sealer To Lower Tabs Of Engine Front Cover Gasket
    GM61819Courtesy of GENERAL MOTORS CORP.
  1. Install the engine front cover gasket.
  2. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent to both sides of the lower tabs of the engine front cover gasket. Apply the sealer no less than 5.0 mm (0.20 in) wide.
    3. Fig 2: View Of Engine Front Cover & Bolts
    GM1401296Courtesy of GENERAL MOTORS CORP.
  3. Install the engine front cover (1) to the engine block aligning the cover with the locating pins.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the engine front cover bolts (3, 4). Tighten the bolts to 55 N.m (41 lb ft).
  5. Install the engine front cover bolts (2). Tighten the bolts to 27 N.m (20 lb ft).
    6. Fig 3: View Of Right Engine Mount Bracket
    GM1401247Courtesy of GENERAL MOTORS CORP.
  6. Install the right engine mount bracket (1).
  7. Install the right engine mount bracket bolts (2-4). Tighten the bolts to 55 N.m (41 lb ft).
  8. Install the engine mount bracket bolts (3). Tighten the bolts to 25 N.m (18 lb ft).
    9. Fig 4: View Of Heater Outlet Pipe Adapter
    GM1369269Courtesy of GENERAL MOTORS CORP.
  9. Install the heater outlet pipe adapter (319).
  10. Install the heater outlet pipe adapter bolt (308). Tighten the heater outlet pipe adapter bolt to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals