LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Mechanical - 3.4L) >> Repair Instructions - Off Vehicle >> Crankshaft Balancer Removal >> Removal

Crankshaft Balancer Removal: Removal

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EN-49010 At Starter Mounting Holes
    GM2044840Courtesy of GENERAL MOTORS CORP.
  1. Install the EN-49010:  tool to the starter mounting holes.
    2. Fig 2: View Of Crankshaft Balancer Bolt & Washer
    GM909519Courtesy of GENERAL MOTORS CORP.
  2. Remove the crankshaft balancer bolt and washer.
    3. Fig 3: View Of Crankshaft Balancer
    GM909522Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.
  3. Remove the crankshaft balancer using the J 41816-A:  remover along with EN 46359:  protector or equivalent.
  4. Remove the EN-49010:  tool.
scientia non olet · About LEMON Manuals