LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Engine Controls And Fuel - 3.4L - DTC P0401 To DTC P2544) >> DTC P0442 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:
    • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize.
    • Ensure that the vehicle underbody temperature is similar to the ambient temperature and allow the surrounding air to stabilize before starting the diagnostic procedure. The system flow will be less with higher temperatures.
    • Refer to the J 41413-200  operation manual for detailed instructions.
  1. Using the GE-41415-50  , connect the J 41413-200  to the vehicle filler neck.
  2. Seal the system and use the flow meter on the J 41413-200  calibrated to 0.51 mm (0.020 in) to determine that there is no leak in the EVAP system.
    • If a leak is detected, use the J 41413-200  to apply smoke to the EVAP system at the service port or the filler neck until the leak is located. For vehicles without a service port, disconnect the purge tube at the quick connector on the EVAP canister side of the purge solenoid valve and install the CH-48096  .