Circuit/System Verification
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Command the EVAP vent solenoid valve ON and OFF with the scan tool. An audible click should be heard when changing between the commanded states.
- Start the engine, observe the scan tool EVAP Vent Solenoid Valve Circuit Test Status parameters. The circuit test status parameters should display OK or Not Run.
- Start the engine, observe the DTC information with a scan tool. DTCs P0449, P0498, or P0499 should not set.
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.