Conditions for Running the DTC

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

P0133

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The HO2S Sensor 1 Heater command parameter is ON.
The ECT sensor parameter is more than 65°C (149°F).
The Engine Run Time parameter is more than 60 seconds.
The vehicle is not in Park, Reverse, or Neutral.
The Loop Status parameter is closed.
The MAF sensor parameter is between 15-40 g/s.
The TP Indicated Angle parameter is more than 2.5 percent.
The Engine Speed parameter is between 1,200-3,000 RPM.
The evaporative emission (EVAP) system is purging.
The Barometric (BARO) parameter is at least 69.8 kPa.
The above conditions have been met for 3 seconds.

P0134

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The HO2S Sensor 1 Heater command parameter is ON.
The Engine Run Time parameter is more than 2 minutes.

P0140 - Regular Test

DTCs P0036, P0054, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The Engine Run Time parameter is more than 2 minutes.
The TP Indicated Angle parameter has changed more than 3 percent at least 1 time.
The Loop Status parameter is closed.

P0140 - Fast Pass Test

DTCs P0036, P0054, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The Engine Run Time parameter is less than 90 seconds.

P1133

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2119, P2135,, P2176, P2A00 are not set.
The system voltage is between 10-18 volts.
The scan tool special functions are not active.
The HO2S Sensor 1 Heater command parameter is ON.
The ECT Sensor parameter is more than 65°C (149°F).
The Engine Run Time parameter is at least 60 seconds.
The EVAP purge solenoid is commanded ON.
The MAF sensor parameter is between 15-40 g/s.
The Engine Speed parameter is between 1,200-3,000 RPM.
The TP Indicated Angle parameter is greater than 2.5 percent.
The Loop Status parameter is closed.
The BARO parameter is at least 69.8 kPa.
The vehicle is not in Park, Reverse, or Neutral.
The above conditions have been met for 3 seconds.

P2A00

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1133, P1516, P2101, P2119, P2120, P2122, P2123, P2135, P2176 are not set.
The Engine Run Time parameter is more than 100 seconds.
The MAF Sensor parameter is between 5-37 g/s.
The Engine Speed parameter is between 500-3,000 RPM.
The ECT Sensor parameter is more than 75°C (167°F).
The ignition 1 signal parameter is between 10-18 volts.
DTC P2A00 runs continuously when the above conditions are met for 5 seconds.

P2A01 - Passive Test

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1133, P1516, P2101, P2119, P2135, P2176, P2A00 are not set.
The engine is running for at least 5 seconds.
The ignition voltage is between 10-18 volts.

P2A01 - Intrusive Test

DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1133, P1516, P2101, P2119, P2135, P2176, P2A00 are not set.
The Engine Run Time parameter is more than 5 minutes.
The ignition voltage is between 10-18 volts.
The Engine Speed parameter is between 625-1,650 RPM.
The MAF Sensor parameter is between 4-15 g/s.
The Vehicle Speed parameter is between 40-132 km/h (25-82 mph).
When all of the above conditions have been met for at least 2 seconds, the following conditions must also be met:
- The evaporative emission (EVAP) purge diagnostic is not active.
- The Short Term FT parameter is between +5 and -5 percent.
- The Loop Status parameter is closed.
- The EVAP purge solenoid is greater than 0 percent.